V2 - Concept and Design

The idea for V2 is to route the connections for each of the 60 LEDs in the SpokePOV up to another configuration. Rather than routing the light with FiberOptics, this uses a series of daughter cards to rearrange the electrical connections for the LEDs without changing any of the rest of the SpokePOV board or programming. This is again overly complex in a way, definitely not an elegant solution, but if it works and doesn't take much time then I don't care.



This is the final artwork for my V2 boards. These were pieced together from 9 parts made in EagleCAD assembled and edited in Adobe Illustrator. I'll be using blue Press-n-Peel toner transfer to mask and etch 3 of each board.